supported blocks -凯发k8网页登录

(dsp system toolbox)

integer delay

dynamic-lookup

(matlab function block)

(stateflow)

(stateflow)

(stateflow)

the simulink plc coder software supports the plclib blocks with the following exceptions. also, see for a list of limitations of the software.

if you get unsupported fixed-point type messages during code generation, update the block parameter. open the block parameter dialog box. navigate to the signal attributes and parameter attributes tabs. check that the output data type and parameter data type parameters are not inherit: inherit via internal rule. set these parameters to either inherit: same as input or a desired non-fixed-point data type, such as double or int8.

if you receive a message about consistency between the original subsystem and the s-function generated from the subsystem build, and the model contains a stateflow chart that contains one or more simulink functions, use the following procedure to address the issue:

to generate plc code for a model that uses a block, first define a object in the base workspace. then, in the signal attributes tab of the block parameters, set the data store name to resolve to that simulink.signal object.

for more information, see .

the simulink plc coder software does not support the simulink block signedsqrt and rsqrt functions.

simulink plc coder has limited support for lookup table blocks. the coder does not support: